Support Center

Name is required.
Email address is required.
Invalid email address
Answer is required.
Exceeding max length of 5KB

Computer or mechanical motion sensing "Timer" for projector?

Cassie Follett Sep 11, 2017 06:02PM CDT

Hello,

I have a BenQ MX631ST. It is part of a permanent installation. To preserve bulb life, we would like the installation's projector to turn on based on sensing motion, and then turn itself off after 30 minutes to an hour. The projector is connected to a computer, so it is my hope that this could be accomplished through customizable software or similar. I was hoping someone may have advice or ideas on how to do this,

- Cassie

Up 0 rated Down
Robert Sep 12, 2017 01:41PM CDT BenQ America Agent

Hi Cassie,

I’m not sure how you can do this, but looking online, maybe a Raspberry Pi with some customer programming. Really your best bet will be to reach out to a computer programmer, as this will most likely need to be a customer coded solution.

Post Your Public Answer

Your name ( (*Required))
Your email address ( (*Required))
Answer ( (*Required))
825595764ed00e7f2e46cb66d733d4d1@benqamerica.desk-mail.com
http://assets2.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete