Support Center

I am trying to control my MW721 via RS232 and get no response from the unit. What should I do?

Last Updated: Oct 07, 2014 02:48PM CDT

When typing the control commands, do not type “<CR>” at the beginning and the end of the command. “<CR>” means enter so you just press enter key before you input a command. Also, the projector will not respond to any command for 1-1.5 minutes after power on. It takes a couple minutes to startup.

825595764ed00e7f2e46cb66d733d4d1@benqamerica.desk-mail.com
http://assets3.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete